2101: Detection error on SSD (M.2)
A problem with your hardware caused Windows to stop working correctly.
Bad CRC1, stop POST task, the EEPROM checksum is not correct.
System Security, the system has been tampered with
Bad SVP data, stop POST task. Checksum of the supervisor password in the EEPROM is not correct.
Bad startup sequence settings. Enter BIOS Setup and load Setup defaults.
EAIA data access error, the access to EEPROM is failed (read or write).
System Security, Invalid Remote Change requested.
System Security, Embedded Security hardware tamper detected.
Security hardware tamper detected
Invalid remote change requested
System Security, Security password retry count exceeded.
More than one modem devices are found. Remove one of them. Press the Esc key to continue.
More than one Ethernet devices are found. Remove one of them Press the Esc key to continue.
More than one Wireless LAN devices are found. Remove one of them.
Hard disk error, the Fixed disk is not working.
Monitor type error, monitor type does not match the one specified in CMOS.
Shadow RAM error, shadow RAM fails at offset nnnn.
System RAM error, system RAM fails at offset nnnn.
Extended RAM error, extended RAM fails at offset nnnn.
System battery error, system battery is dead.
System CMOS checksum bad, default configuration used.
Password checksum bad. the password is cleared.
date and time error, neither the date nor the time is set in the computer.
Previous boot incomplete, default configuration used.
Attached docking station is not supported
Unauthorized network card is plugged in, power off and remove the Mini PCI network card
Unauthorized daughter card is plugged in. Power off and remove the daughter card.
Hard disk partition layout error
Invalid memory configuration - Power off and install a memory module to Slot-0 or the lower slot.
Initialization error on HDD1 (Ultrabay hard disk drive)
Read error on HDD0 (Main hard disk drive)
Read error on HDD1 (Ultrabay hard disk drive)
エラー 629:この接続はリモートコンピュータによって切断されました。
エラー 651:モデム(またはほかのデバイス)からエラーが返されました。
エラー 691:指定したユーザー名またはパスワードが認識されないか、選択した認証プロトコルがリモートアクセスサーバーで許可されていないため、リモート接続が拒否されました。
エラー 720:リモートコンピュータへの接続を確立できませんでした。この接続用にネットワーク設定の変更が必要である可能性があります。
エラー 813:同じデバイスまたはポートを使って既にブロードバンド接続を確立しているのにもかかわらず、2番目のブロードバンド接続を確立しようとしました。